Could anyone help me here,straight after i installed new version i kept getting message "unable to open port com1".
Someone here told me that i probably have ticked wideband,which i dont have and that was causing the problem.Anyways i managed to get connected and when logging car starts to misbehave,revs by itself,then cuts out and Engine light keeps coming on and then evoscan disengages.And every time i start logging agin same thing happens. Im now using old version 2.0 which works fine for me.
Any ideas guys?

Do you have the white connector pluged in? If so try logging without, it's only needed for flashing.

MB

Xpro,

Try unchecking all the paramenters. Then start checking them up except for the wideband.
I have the same problem earlier and somebody in another thread said its because I have the wideband checked when I don't have a connection for it.

gunhaha

Xpro,

Sorry for my post. I thought you are still having issue with the the COM1.

Anyways, try not to connect the white 12 pin connector when logging as this is used only for flashing and saving from the ECU.

gunhaha

i had a same problem with my 2.0 when the baudrate was wrong!
baudrate must be 15625 in the device setup box.

thanks for all the info.i think i know what the problem was.my baudrate was 19252

yup baudrate happen to me also, for some reason it dissapeared, i had no idea what it was, i tried a few different ones and it made the whole car shake, LOL,
i keep a word doc with the baud rate, immobolizer code ect just incase that ever happens again.