Hello,

want to install the 272 cosworth cams in a few days, was just wondering what should i do with the mivec table. Currently im running the table from the "mivec tuning" thread. Any other map for 272 cams?? any tips regarding on how to tune my map for 272 cams??


krgds+
Elie

 

It would seem that the MIVEC map for the JDM RS works really well with those. There is a thread around here somewhere that talks about Cosworth MIVEC in particular. I will look for it and see if I can find it.

 

https://www.evolutionm.net/forums/sh...d.php?t=302907

 

Hey John, thx a million for your help

after reading the abv thread, i was nothing but confused, just like every1 else hehehe

do u recomend the mivec map you posted on the 1st page of the thread to be used with the cosie's ???


thx

 

Yes EE, that one will work. Remember though that the 30* was a mistake on my part and it wont actually go higher than 28.8*. The rest of it will be a very good starting point.

JB

 

well will do

my plan to fine tune the map is to zero out error correction in the solenoid wgdc, and mess around with the mivec map with fixed solenoid wgdc.

Then will log for 2-byte load, if the load increases with the fixed wgdc, then i know my new values in the mivec map are better.


thx again