Im not sure where i was looking or if i even did it. But I could have swore that i seen directions to change some of the mut addresses in the table when installing a jdm map sensor. But now going through it all again i dont see the same directions. So if anyone could either post a pic of there mut table or tell me mut addresses in the top row.

Thanks
Jeremy

 

Never mind figured out what i was doing. lol. But another thing but still pertaining to the 3D MUT table. When you read the MUT address is it accoss(x) then down(y) or down(y) then across(x) ?

Thanks again.

Jeremy

 

down(y) then across(x)

Eg: 01 = column 0, row 1
02 = column 0, row 2

Ignore FFFF

 

Thank you. I did it right then. phew.