Anyone have 94170015 Rom with 2 Byte load?

 

https://www.evolutionm.net/forums/ec...te-thread.html

 

ive tryed adding the 2 byte to it but where is the xml file for the rom?

 

were you able to input the numbers in the 2byte thread to the MUT table in your ROM?

 

Bump. are the MUT00 and MUT01 8960 and 8961?

If so, the information blasted errwhere on here (and the wiki) needs to be changed. They all show 895C and 895D

please confirm

 

where did you get 8960/8961 from ???

 

Look at the second-to-last page in the 2 byte thread. Very top. (I would post a link but I'm on my phone)

 

then 883c/883d would be 2 byte load and 8960/8961 would be 2 byte load baro/iat compensated . If your at high elevation use the compensated one

 

oh, ok so I dont need to use that.

Well I have another problem. When I go into ecuflash and open my 2 byte load HIGH and LOW tables, what values are supposed to be input?

I have put in 0x895C for high and 0x895D for low, but whenever I change each, the other table automatically changes!!! both will not stay constant

 

you put those values in the mut table yeah??

 

they were already in the mut table...

I added the code to the rom's XML so 2byte load, rpm, and airflow could show in EcuFlash, and I used the correct addresses above (I did not use 8960/8961)

I saved, then opened up EcuFlash, and then tried inputting the correct values (not too sure what they were originally), but no dice

 

what exactly are you trying to do is it just to log 2 byte load ??

 

I am trying to log 2byte load, RPM, and I dont really need airflow, but Im doing it for ****s and gigs.

I am logging without a laptop using an Openport 2.0, So I am also developing the correct codes for that. But its pretty simple, you just point it in the direction and it logs it. For the 2byte load, for example, my code is:

paramname=Load2byte
paramid=0x00
scalingrpn=x,0.3125,*

with 0x00 being 895C (at least I hope)

 

maybe I shouldnt mess with the predetermined table values in ecuflash?

 

good call