Logged for the first time today...Mainly to tweak my timing to remove knock...and noticed my estimated torque peaks at 300lb/ft....How accurate is this number? My mods are as follows...ebay ported o2 housing and 3"tbe, gm 3 port running 22.5 psi. Or maybe this has been covered, but if it has, I didn't see it in any thread topics.

 

When I wrote that piece of math for EvoScan it became obvious very fast that it is only accurate if-

Pumpgas only
Stock airmeter
Intake kit that doesnt affect the MAF
MAF scaling stock

 

Nice to have a definative answer isn't it!

You should use jackofalltrade's dyno sim.

 

I think I will...and my car's intake system (including MAF and scaling) are all stock....it just surprises me to see that number with just a tba, o2 housing, and boost increase.