So I'm trying to get my car starting consistently and idle.
Quick Mod list
2.4
FIC2150 Injectors
SD w AEM 5Bar
FP5R Cams
3794


I've seen some discussion in this tread
https://www.evolutionm.net/forums/ecuflash/482329-fic-2150-scaling-helllllllllppppp.html

Currently the car barely starts and holding down the throttle I keep it running almost to 1000rpm's (93 octane)

Should I only be using the injector scaling? I know some people adjust latency but I've heard people suggest they constant parameters of the injector.

 

You should be able to get the 2150's to idle by just adjusting the injector scaling AND the latencies. I believe JohnBradley (aka Aaron) made a post with somedecent injector latency values for those injectors, just do a little searching in this section of the forum. Leave the other tables at their original settings for 93 octane.

Do you have a wideband? What is it reading when you have idling issues, is it lean or rich?

-Jamie

 

Those are exactly what I used. Still had trouble


The combustion is soo erratic the wideband is going all over the place (way rich then lean)

 

Any suggestions, or general procedures for getting the car to start/ idle consistently?

Also setting latency?