Hello to everybody!

I am the happy owner of Evo 5 GSR.
My setup is:
Turbo Evo 9 80 series
Turbo back Japspeed S1
Elbow Japspeed
Fuel pump DW200
Blitz air filter
Turbo gauge SRTI

I also have an Open Port 2.0 and EcuFlash and I would want to install a MAC 3 port boost control solenoid.
I shall like increasing the pressure in 20psi.
How I have to proceed to increase the pressure with ecuflash?
What regulations I can make to improve the mapping?


Thank you for your help

 

I've had the privileged to tune a couple of Evo 5/6's and its all about the same as the Evo 8 stuff. Just read through the guides for the Evo 8 and you'll notice it all lines up with the Evo 5 as well. Just get the Rom off the car, find the definition files for it and start reading up on what does what and you'll be good to go.

Heres a good write up for a 3-port-gm-boost-solenoid install with the additional tuning requirements for you to look over. The MAC 3 port boost control solenoid may be a little different so do your research just in case. I personally like the GM 3port more. how-control-boost-using-ecuflash-3-port-gm-boost-solenoid