Do any of the venders have these in stock??? I need one by next week and I cant have my car down while I send my own into buschur to have it upgraded... Any Help???

 

I hear ya im tryin to get one for the tune too but i dunno if its gonna work. Looks like me and you are going to have similar mods lol

 

Lots of vendors should have these in stock. Have you already contacted each one in our Vendor section? If none of them have one, then contacdt TTP-engineering by sending an email to sales@ttp-engineering.com. He should be able to dropship you one for $170 in no time...

 

Sorry for the delay on these we have been swamped with orders and we are working hard to supply the US office with replacements

 

Yes we have these in stock. About 10 left. Email sales@TTP-Engineering.com. Please specify either blue or red spring configuration or ask me if you don't know the difference.

Thanks!

 

I am not ordering one, but I will ask anyways...whats the difference?

 

We have tested both. Forge recommended the blue. We tried the blue and minimum boost was 13-14psi. We were not satisfied with that. We swapped to the red and with our shimmed actuator rod are at 19-20psi min. So basically cranking the MBC all the way down you are at 19-20 which is safe pump gas level and you go up from there. Without cutting the rod, you should be at 17psi or so on the lowest boost setting.

We have hit and datalogged 34.1 psi using the red spring and a Hallman Pro Rx Evolution MBC which we also sell on our site. We believe to be the record holder for stock turbo torque now @ 445.1 tq. This was on 93 octane and meth injection.

 

Close.. we got 462tq on our shop evo with the stock turbo and c-16. That was before building it to what it is now... But I guess your the record holder for highest tq with MR on stock turbo

 

Good Work as usual Doug. Cheers

Maybe the speed density AEM and timing control was a help?
Nasty tire shredding tq Drift King Evo

There was a max tq on stock turbo thread that I did not see yours listed on... You should post up.

Anyhow, 8 more units left in stock.

 

Wow, big interest in these... Have only one left and they are into backorder once again.

Thank you for the orders!

 

OK sold out!

Jorge gets the last one...

I can bump the thread upon the next shipment!

Thanks again!

 

I have them in stock for those in need of an actuator.

 

OK, just a few back in stock again!

PM me for special pricing.

 

New stock on the way to the US office on Tuesday

 

All PM's returned. Thanks for the interest. Still have about 4 left.