yeah should be getting it early next week.

my 10.5 hotside is back from being milled and its done being coated. the IX compressor housing and 20g wheel are al there they just need to be put together. the guy who assemble the turbos is out sick, so likely robert the man himself will be putting mine together..

been a long wait.

 

Did you win the lottery?

 

Its basically a stock in every way except the power! Love it

 

where da green?

 

Installed cams, ARP's, and walbro...

Few pics of install..

 

I know you can't wait. I'll be following in your footsteps the end of this summer.

 

yeah, I am very excited to finish this set-up. Its very over whelming sometimes with all the things that i have to install when they come at once though!

 

nice setup and good to know the lead time of the evo green isnt' too bad if you order outright like I was planning on doing.

 

so far so good

 

did you order the green from BR or FP?

 

[

Quote:

quote=Mellon;4419040]did you order the green from BR or FP?

[/QUOTE]

See reply in post #10 of this thread for answer to your question.

 

^^ thank you, amazingly I missed that.

since you got it from FP, which options did you go with?

Ported?
coated?
WG spring?

I'll probably just do the ported version, I wonder what options the BR version comes with standard since they don't show any options other than the WG spring.

 

Nice.......I wish I had the patience to wait and get all my parts together before doing it all at once.....

 

Mellon, i got the Evogreen with all the options...18 psi actuator, ported, ceramic coated, and the 10.5 nozzle

 

good info thanks. I'm going to put my order in next week, just the ported 10.5 option though.