Hey Guys,

I was looking into the Brian Crower Pro series rods. I will not run more then 700awhp. Will these rods do the job. I spoke to them directly they say they cna hold 1000hp no prob. The only thing that bothers me is that they have a H-beam design. Also the wieght of the rod is 573 grams. the plus side of these rods seems to be the NEW APR 625+ custom age fasteners. Any experiences shared with these rods is greatly appreciated. thanks in advance.
Suman

 

bump anyone?!?!?!!?

 

Im using them in my 2.0L with a GT4294R. Not looking to make anywhere near 1000hp but hopefully a decent amt. The machinist said they checked out fine and they went together very well. I have a little over 500 miles on the engine and it should be turned up within the month. So far theyve been fine.

 

thanks the lab. Just spoke with Brian himself he assures me they are good to over 1000hp. He says the H beam technology is like that of Carrillo and the 625+ APR fastners are the best. I think we are in good hands.


S