I tried installing a recirculating Forge RS bov on my car. The problem is that it doesn't fit because the bov would be too high and push up the radiator hose. The intake is a aem intake. Any body know which aftermarket uicp would fit the Forge Rs to the aem intake? Or is it just me?

 

Anybody? Which uicp are you guys running with your Forge RS?

 

I have the Forge RS , AEM, and ETS piping. what I did was put the Forge on the UICP, and run the relocation tube back to the AEM SRI.

 

Do you have the ets uicp with the small battery?

 

Yes , I have the short route piping, but my battery has been relocated to the rear. ETS FTW

 

Can't you rotate the intake? So that it fits?
FWIW my forge sits directly in the stock intake and a small (that stock curved one) rubber pipe runs from it into Injen UICP.

 

^^I could make it fit, but the knob for adjustment would be facing down towards the tranny. Where does your forge sit? directly under the radiator hose?

 

Bump!

 

The adjustment knob should be towards your exhaust mani, not up. You can try to purchase a piece of hose from the autoparts store with an angle in it if all esle fails.