Just got a call today from buschur. My map sensor was damaged while being shipped to them. If anyone has a Map sensor let me know. Thanks

 

bump. Anyone know where i can get one cheap?

 

you could try junk yards in your area. you could also change to a 3 bar map if you are using stock ecu.

 

Im using an AEM. Im going to run my stock computer for a week or so until my aem gets installed.

 

bump. Everything is just about ready to go. Still waiting on turbo kit. Hoping to have it by this weekend. I need to get my car out of the garage.

 

Heres a few updated pics. I dropped the motor in finally. Turbo kit is bolted up. Buschur did a great job on the turbo kit. Couldnt be happier. I finished hooking up the harness. I had to customize the licp a bit to fit up. I should be driving it by this weekend =)

 

 

Swwweeeeeeeeeeeeeeeeeeet

 

AMEN, I lifted my car way up on jack stands and just dropped the whole motor on a dolly and wheeled it out. Worked great, and leaving the manifolds on? what point.

 

Well now I look later on your past that part LOL

 

Looks great, love the finish on the Valve cover

 

thank you. The reason why i took the head off with the manifolds was i wanted to check the pistons/rods/cyclinder walls out before pulling the rest of block out. Then i was like what the hell i might as well just build it. =) Also i pulled motor out from top. Found it to be very easy. I never dropepd it out below so i wouldnt know which is easier.

 

The car is finally running. Ill try to post up a video tonight. I put about 100 miles on it so far =) i need a tune bad. Not sure where to go yet.