I installed it couple of weeks ago, and haven't had the time to post but the problem is that when i set my PSI it wouldn't quite work. I can only adjust my PSI at the OFS and its @ 135 boosting @ 17.5 psi. I have checked and the EVC was installed correctly, tried to restart it and tune it again but it doesn't seem to work. I just cannot set an exact PSI.

 

Did you set the wastegate pressure properly? Have you set the RPM levels for the correct values? Lot of factors in your set up need to be known for proper input on this issue.

 

Thanks Mitch ill just pm you for this because i dunno what the heck is going on