Wich camshafts??
Wich camshafts??
JUST TO SAY THERE WAS NOT THE CAMS OR THE VALVE SPRINGS WHO CAUSED THIS PROBLEM!!!!
I have had a serious problem with my car this year.
I run brian crower 288 cams, all exhaust valves has min leeks after just a few miles.
Changed all valves to new ones and tried again with the same result.
There is no marks on the pistons or either the valves.
It must be the cams that are the problem i'll guess.
Or is it just cheap valves?
So i'm thinking of kelford 280 cams!?
My setup is (evo3)
Manley i-beam rods
Wiseco hd 8,5:1 pistons
Fully ported head
1mm os stainless valves (35intake 31,5exhaust)
Jmf drag version intake manifold with att bbk 1503# trottlebody
Precision hp6262 turbo
If i posted this in the wrong section please redirect me.
//Anders
I have had a serious problem with my car this year.
I run brian crower 288 cams, all exhaust valves has min leeks after just a few miles.
Changed all valves to new ones and tried again with the same result.
There is no marks on the pistons or either the valves.
It must be the cams that are the problem i'll guess.
Or is it just cheap valves?
So i'm thinking of kelford 280 cams!?
My setup is (evo3)
Manley i-beam rods
Wiseco hd 8,5:1 pistons
Fully ported head
1mm os stainless valves (35intake 31,5exhaust)
Jmf drag version intake manifold with att bbk 1503# trottlebody
Precision hp6262 turbo
If i posted this in the wrong section please redirect me.
//Anders
Last edited by flandrs; Dec 8, 2010 at 02:16 PM.
valve seats are ok, the seats is full race and is done i mira.
when i mounted everything for about 100km ago.
i tested all valves with e85 and there was no leaks, now the e85 just runs trough the valves..
what do you think of kelford cams?
when i mounted everything for about 100km ago.
i tested all valves with e85 and there was no leaks, now the e85 just runs trough the valves..
what do you think of kelford cams?


