i have this Perrin fuel rail i bought here on Evom years ago and i just got around to installing it but in doesnt really fit the injectors properly. i can barely get the harnesss clips to slip on to the injectors. i have to loosen the rail to get them on, and the inectors are greddy/ denso 720cc.

has anybody have similar problems? i would like to sell this rail and would like to be 100% sure its an evo rail before i attempt to sell it.

thanks

 

It is for sure for an Evo. I've never had a Perrin personally, so I'm not sure about the fitment issue. I've also never had a problem with the injector pigtails not reaching the injectors after a rail install. It SHOULD mount in the EXACT same location.

How much were you looking to get for it anyway?

 

well it mounts to the manifold fine its just too close to the injectors but the same happens with my AMS rail, must be the injectors then.

i was looking to get $50 for it

 

bump for anymore input, the injector clips reach the injector just fine, its the injector itself where it plugs in to the clip sits too tight to the rail not allowing the harness clip to slide on, i have to loosen the rail from the manifold to give it play so its the clip slips in,,,, i dont know maybe im using the wrong o-rings lol.

im just looking to sell this rail and want to make sure it is for an evo before i post it for sale.

thanks for any input

 

Why not call perrin as ask i a looking for a perrin rail but

 

Color is about right but the letter is different than my Perrin fuel rail.

My looks like this one.
http://www.sportcompactonly.com/imag...errin/2332.jpg

Maybe it's an old one or a knock off *shrugs*