okay, so i spun a rod bearing. everything is going to the machine shop to be cleaned.

what do i do with that CHRA of my ball-bearing turbo? force oil through? disassemble? i've never had to worry about these before

any advice from anyone that has been through this would be helpful. thanks in advance.

 

I flushed mine with brake clean, filled the line up, spun it some, blew threw the lines with air, and then filled the line with oil and spun it while it drained.

Don't know if this was the way it's recommended, but this was on a 70k mile turbo, and it lasted another 20k till I blew the motor up. It's still peachy, so it worked for me.