Pics of my APEXi boost gauge
Originally Posted by alloyic_rs
why arent the hands on the tach and spedometer lit?
. The hands are not as bright as I'd like them to be, I might have a bulb or two out, but they are lit, I'm not motivated enough to tear it apart again. They are not perfect, but for <$100 IIRC I like em. I have a couple pics of the overlays (pre-installation) that I could post if anybody is interested.
where did you get the overlays. looks good at night. I have the same gauges but I went a little crazy. I have a total of 7 gauges in the front. when they all light up my oem gauges is overwelmed by all of the indiglo gauges. I would like the oem to match the indiglo ones.
Same place where I got mine from. I didn't drill thou, I used the mounting bracket with the double sided tape, it's been holding quite well for over 3 months.
Originally Posted by klink5
Ordered from here
http://turboimport.com/catalog/gauges.htm
Took about a week
Came in a nice clear plastic box w/ 6ft of 5/32(4mm) hose, tee, (2) wire electrical connector (too short) but not a big deal and mounting bracket.
http://turboimport.com/catalog/gauges.htm
Took about a week
Came in a nice clear plastic box w/ 6ft of 5/32(4mm) hose, tee, (2) wire electrical connector (too short) but not a big deal and mounting bracket.
Originally Posted by savageevo
where did you get the overlays. looks good at night. I have the same gauges but I went a little crazy. I have a total of 7 gauges in the front. when they all light up my oem gauges is overwelmed by all of the indiglo gauges. I would like the oem to match the indiglo ones.
well almost 
Nicely dine
Just have to watch your fuel level now(the low level light is covered up) it took me a while to figure what was missing.
Where did you put the dimmer?
Mine is here.....see pics
Just have to watch your fuel level now(the low level light is covered up) it took me a while to figure what was missing.Where did you put the dimmer?
Mine is here.....see pics
Thread
Thread Starter
Forum
Replies
Last Post
