Is that supposed to match the dash? because that lower section looks waaaay off.

 

thanks guys! im loving it soo much.
i think i might go deaf. haha

well i ordered it from Orbital in early october. than after 2 months of waiting, I heard that 201 motorsports had 10 in stock. so i place an order with them, cancel my orbital one, and get mine from 201 in about a week.
makes my interior 100x better in person without a doubt

 

did u run into any problems, my orbital is stitting in my room, and im just wainting on the kenwood to arrive along w/ the back up cam and sirius.
hopefully its all straight forward

 

Check your climate control panel to make sure the buttons wont stick when you stick it in your car. If it does you may need to sand the back a little. Other than that it took me about 1 hour for the full install.

 

I dont know if this is an MR only issue or not, but i need to cut dash bracing:

https://www.evolutionm.net/forums/sh...d.php?t=315620

 

its not just an MR issue. the instructions say to bend those brackets, but they were still in the way, so i cut them out as well
and my AC buttons were stuck too, i had to cut out a portion from the inside to make them fit better

 

my brackets just had to be bent and the ac buttons where stuck so i shaved a little for the top and it went in fine.
the finish of the the kit is crappy looking and not worth 310. but it's the only 1 out