installed my type s yesterday and noticed it barely almost rests on the heat shield. is this a ok? or could it possible melt the metal on the bov at all? and if so any quick fixes? thanks guys.

 

It should be fine. You could try to bend the heat shield out of the way.

 

Is that VTA? If you recirculated it, it shouldn't be that close

 

its vta...i wuda like it turned up/positioned differently, but unfortunately it had to goto the side like that bc it was hitting the radiator fan. and i had such a hard time getting that in the tubing that even its angled like that i just didnt care...

 

move the hose behind the uicp piping itself "reversed" then it will be fine..

 

ahhh...good call. ill give that a shot. thanks.

 

Why VTA? It kills performance. If you must VTA, there are much better BOV's around. Why VTA?

 

Cut the rubber return house some.

 

vta bc thats how my blitz came when i bought the car. and thats how i bought the greddy. and yea i was thinking of cutting the hose some as well. im guna try turing it in the other direction and see if it works, and if not ill trim a couple inches off the hose.