Can someone show me their Injen LICP installed with stock IC and couplers?...

Mine just wont match up..


oh and I search and found NOTHING I suck at searching

 

SJ I thought you were switching to the AMS??

 

No actually I was going with the ETS, but the pipe the guy sent me is for their IC core.....I looked it up and the pipe I have is shown with the Intercooler setup kit with piping. So I have sitting here the ETS lol And the Injen. I have to send back the ETS to the guy. Meanwhile I can get this Injen to fit for the life of me lol......

 

All of ETS non turbo kit IC piping fits the Stock IC I thought. Since thier FMIC's fit the stock piping.

Give Tom at ETS a call he'll answer all you questions

 

i remember mine was a bit of a pain...and i have the spearco intercooler....i leaked bad with the worm clamps even when i thought they were tight...i always am nervous buying used stuff, but i cant really afford all new stuff.....i have a used set of hks 272's on the way..

 

I got mine to work with stock intercooler and couplers. It was a pain in the but though. Turning the coupler made it easier to make connection. Turn it toward the turbo a little. It is easier to connect it to the intercooler then to the turbo. Make sure not to fully tighted down the clamps until you have everything on. KevinD did mine in a parking lot with a screw driver and no jack ( i have removed my undertray).

 

I have a thing I do with the worm clamps to insure sealant.......As I am slowly tightening them i heat the coupler around the clamp with a hair dryer....Untill I can afford more t clamps. I planned to call ETS tomorrow, but I am covering my basis with this thread in case he has no answers for me.

 

check evomoto.com, technical section. That what I'm using right now for my planned intercooler and LICP install.

Is it me or do I keep hearing the injen IC pipes have fitment issues???

I ordered my $hit off of xs-power.com (its an AMS clone) I plan on doing a thread on it when am done w/ it.

 

eeeehhh god luck my friend...xspower has POOR customer service... I MEAN POOR, plus I couldnt get my XSPOWER LICP to fit the stock bumper, nor could I get there IC core to fit either......I know they are cheap and people swear by them, but I think its because they made modifications to make it fit......And yes I am having a problem fitting my LICP from Injen.....

 

They dont have the Injen LICP install how to, thanks though

 

Ill let you know what happens. I checked out the AMS intercooler and its the same thing. The same goes for their LICP. I'm going to try and install it tomorrow morning once I get off of work.

 

ok....if its the same thing then I think the ams wouldnt fit either, I was in the garage for 10 hours one day trying to make it fit....nothing

 

Im looking at EVOMOTO.com's technical section and they have a DIY on it. It looks like a breeze but I'll post up the results.

 

good luck

 

Bolting on an IC and IC piping should not be a chore by any stretch. Its one of the easiest thing you can do. If you are haveing issues these parts are crap.

I have a logic performance LICP and if it took me 30 min to put it on thats alot. The Injen UICP fits without issue. It literly takes no time to install. Maybe you need to take it to a shop to get it worked out.