Hey guys, putting together a Evo 9 front bumper together but clueless as how the lower intercooler mesh goes on? Where does it screw into, what size screws do i use and how many? Searched but no luck.. if theres a diagram of sorts that be but any input would be appreciated! thank you guys!

 

I dont know of a diagram or anything. From what I remember they are kind of like little staples/brads for paper in folders. You put the mesh over the little spikes and fold them over to secure the mesh in place.

This is about an evo 8 bumper but might give you an idea: https://www.evolutionm.net/forums/ev...nt-bumper.html

 

should be similar but I can't guarantee that

the mesh is affixed to the metal bar across the top and gets bolted in on each end...the bottom is held in by bronze bolts 10mm I believe

 

thanks Chaotichoax & Jake!

the metal bar across the top gets bolted in on each end with a regular Phillips head screw? Kinda looks like it..

 

Hope this helps...

 

yes phillips pan head on each side

 

 

always hated those sheets...so many pieces to try and comprehend in a flat image with no color or directions

 

ak47 big ups! thank you much! I wish it listed blot size.. they look like (6)10mm from the pictures Mitsuclipsegsx posted (thank you too!).

 

.. off topic but where can I find diagrams like that? I’m also looking for disassembly/assembly of the side skirts

 

mitsu service manual

 

u can half azz it... it doesnt need to be exact bolt nut size. just use a clip and screws that fit.