Welds are not the greatest, they look ok but I have seen much much better from ETS and AMS. They did not do any clean up work on the intake pipe they produced. I had to take a dremel to clean up the crap they left. I have seen it on their upper ic pipes too. I have heard if from a few shops they would never recommend JMF products and neither would I.

And to the guy that said they do CBRD's welding, ok so what?
I never said CBRD wasn't good quality. I will be getting rid of the parts and fixing them with something else like ETS. I guess it is a hit and miss like most products.

 

Our intercooler core is the same core that BR, ETS, etc will use if you ask-

It has supported 768whp on our dyno

also-

I will stand up to ANY negative comment about JMF- we have a partnership on our production-

CBRD does prototyping and testing/development and JMF then does the production of our parts-

so if you buy a CBRD product that is not one off production- JMF is doing the production of that part for us

We are proud to work with them- and have considered even moving into the same facility because we share the same philosophies and are already close geographically!!

---------

sorry to rant- but I will always defend our business partners.

CB

 

Sorry Chad but the parts I got were sub-par in my book. I can understand wanting to defend friends but without seeing the condition of the parts it is hard to defend. I didn't take pictures of the before/after but I was extremely dissatisfied in my purchases. When paying $350 for parts, I should not have to come through and do clean up work when all I read is how nice the stuff is.