Searched around and cant seem to find the best location on the upper intercooler pipe. What are your suggestions? I would think closer to the throttle body would be good and just extend the pig tail wires, or do you reccomend closer the the wire harness of the maf to wire it up? thanks for your input.

 

Has anyone run the sensor in their intake pipe?

 

Didn't think most tuners were using IAT's for SD conversions anymore. Just mimic Fuel Temp

But yea if you are going that route I've always seen them welded on the straight of the UICP

 

I have mine in the upper pipe right before the 90 degree bend that goes into the throttle body.

 

^^^ you are correct they don't use it anymore but lots of guys see SD conversion kits for sale and are confused thinking they need it.my car was converted yesterday without IAT sensor.

 

IAT sensor no longer needed for SD conversion.

 

I put mine in the upper pipe down by the trans to keep it from heat soaking.

 

thanks for the input. My buddy said they dont need it anymore but he wasnt sure, hes a supra guy.