HI all,

however, i had just noticed my licence plate globe was not working.
This globe had only been changed recently to an LED (T10).

what i had noticed, is that the wedge type bulb is a little loose in the socket. fiddling with it a little seems to turn it back on.

I tried to use a small screwdriver to perhaps bend the metal contractors on the actual socket in hopes of tightening the fitment. the fitment seems tighter if you close the gap of the metal contractors, but didn't seem to really help.

I ended up putting it back in and reinstalling it by keeping it in the position that it doesn't drop-out… so I'm not sure if this will happen again.


anyone else experience this and has found a solution?

regards,