Was wondering if any of you may know the torque specs for the following:

Flywheel
Pressure Plate
transmission housing
Transfer case

I am almost done changing my clutch, I have taken a ton of pics and hope to do a good write up for you guys. I just can't seem to find these specs, I have searched but no luck. Any help would be great.

Thanks,

Shane

 

98 +/- 3 ft-lbs
13 +/- 2 ft-lbs
36 +/- 3 ft-lbs
51 +/- 7 ft-lbs

 

Thank you so much. I love this site . If you don't mind me askin where did you find these specs? Thanks again.

Shane

 

In the service manual:
11A-41
21B-2
22A-22
22A-17

Yes, I've been doing my homework for the upcoming job myself

 

Looking forward to your write up on the clutch install. What difficulty rating would you give it, and about how long does it take..

Thanks for helpin everyone out!

 

Well I would say on a 1-10 scale about an 8.5. Its not to bad so far. The flywheel is being resurfaced right now. We got the trans out without removing subframe or transfer case. You more or less have to just wrestle the tranny out, it takes some finessing. I will be putting it back in either Tuesday night or Thursday. So far we have worked about 3.5 hours.

Shane