Hey Guys, I like many on the board have purchased second hand Cusco V-Braces for our Evos. These usually don't come with instructions and I was hoping one of you guys could help me out with a little write up. I'm just stumped about where to drill and exactly what to drill. Thanks very much...

 

check out these pics here







What you want to do is mount the v brace up without drilling any holes first. Tighten everything down and mark the holes into the sheet metal.

draw a cross like shown for the best accuracy and becareful when you drill, the sheet metal is very thin and will take less than 10 seconds to go thru.

 

Thanks very much!

PS: How do you get the bracket under the car though? I mean to say is it easily accessible, Will I see where it goes once I get underneath the car? Thanks again.