I just got my OT-2, but would like to link my uego to the OT-2 for logging the data. looks like it should work fine, but how do I link them. I know I will link the blue wire to the serial in, but not sure what kind of connector, and is there any thing else I need to do? (I think it calls for a 3.5mm plug) is it mono, or stereo,if so how do I wire it) I am using this wirelessly to my iPhone, I have already got that hooked up, just need to figure out how to get the wide band linked to the OT-2.

 

Just took a look around for you, please be warned this is just a guess but I think I found good info--


OT-2 2.5 stereo jack: male plug [UEGO info]
Tip = #1 : Tx Data is Black Wire [Tx on uego is white]
Middle = #2 : Rx Data is Red Wire [Rx on uego is Grey(serial)]
Base = #3 : Ground is white [assuming sensor ground]

This is all I could find from referencing numerous posts, so someone please confirm, this should not be assumed correct.

And Goodluck! Let me know what ya get.

Steve