new ramz! 18x9.5 cosmic blue grids
I have this same set up S tech tien springs and stock struts and i use goodyear eagle 245/40/18. I did not buy the tires( it came as a combo) but if i had to do it over I would have gone for the 255 in goodyear or the 265/35/18 in yokohama s drives. The goodyears are too tall for a 40 and tend to rub on bumps and full lock turns
The G units are a +30 offset so I use a very slim spacer to clear the brembos by a hair in the fronts. no spacers needed in the rears. But if you are going with the 9.0 width I would definatly get the fronts rolled. The rear is your call. I'd post pics of my whip, but I don't want to jack this dudes thread. Unless its cool. Peace for now.
The G units are a +30 offset so I use a very slim spacer to clear the brembos by a hair in the fronts. no spacers needed in the rears. But if you are going with the 9.0 width I would definatly get the fronts rolled. The rear is your call. I'd post pics of my whip, but I don't want to jack this dudes thread. Unless its cool. Peace for now.
and blown struts. 
Thread Starter
Evolving Member
iTrader: (3)
Joined: May 2008
Posts: 368
Likes: 1
From: lewisville TX
Danger Zone!!!I dunno, it's your car, your call. Just doesn't make sense to remove something like that...
Last edited by Babs; Jan 19, 2010 at 06:26 PM.
Thread Starter
Evolving Member
iTrader: (3)
Joined: May 2008
Posts: 368
Likes: 1
From: lewisville TX
Danger Zone!!!Because the size of the rock matters. If it can get through the mesh, it probably won't do much damage. Take the mesh out and have a boulder flung at you that would've been normally stopped by the meshed and you probably won't be so lucky. I don't know if you've taken all the mesh out but if you have, then that's your radiator at risk too.
I dunno, it's your car, your call. Just doesn't make sense to remove something like that...
plus that would give me a reason to get a new radiator! but the IC would suck... silicone baby!
