I searched, but the only thread w/potential info has a link to socalevo.net... which is down. Does any one have the torque specs for the bolts on this install.... ie.top(mounts) and bottom of coilover?

Any help would be appreciated.

 

Go with stock specs if you have them handy. If you don't, do not over-tighten. While you don't want it too loose, tighten it reasonably and don't go overboard.

 

I am looking for the stock specs if anyone has them.

Thanks again!

 

Here ya go, this is from the '03 CD manual . . .

FASTENER TIGHTENING SPECIFICATIONS M1332008500197

ITEM SPECIFICATION

Front axle crossmember bar

Front axle crossmember bar bolt 49 ± 10 N·m (37 ± 7 ft-lb)

Lower arm assembly

Lower arm to crossmember connection bolt (Rear) 167 ± 9 N·m (123 ± 7 ft-lb)

Lower arm to crossmember connection bolt (Front) 186 ± 10 N·m (138 ± 7 ft-lb)

Lower arm to knuckle connection nut 108 ± 10 N·m (80 ± 7 ft-lb)

Stabilizer bar

Crossmember to body connection bolt and nut 167 ± 9 N·m (123 ± 7 ft-lb)

Crossmember bolt 49 ± 10 N·m (37 ± 7 ft-lb)

Rear roll stopper connection nut 52 ± 7 N·m (39 ± 5 ft-lb)

Stabilizer bar bracket bolt 39 ± 5 N·m (29 ± 3 ft-lb)

Stabilizer bracket bolt 21 ± 4 N·m (16 ± 2 ft-lb)

Steering gear and joint connecting bolt 18 ± 2 N·m (13 ± 2 ft-lb)

Lower arm to knuckle connection nut 108 ± 10 N·m (80 ± 7 ft-lb)

Tie rod end to knuckle connection nut 25 ± 5 N·m (19 ± 3 ft-lb)

SPECIFICATIONS

FRONT SUSPENSION 33A-24

Strut assembly

Strut nut (self-locking nut) 60 ± 10 N·m (48 ± 4 ft-lb)

Strut assembly to body connection nut 44 ± 5 N·m (33 ± 3 ft-lb)

Strut assembly to knuckle connection nut 167 ± 9 N·m (123 ± 7 ft-lb)

 

Thanks!!!