Was wondering if nyone can give me some tips on adjusting these coilovers. Got it with the car and most of the videos i've seen there are three perches but the tein basic only has two. How do i adjust height, do i just losen the bottom perch and turn the top?. I am also having some difficulties trying to losen them too. Should i turn both perches at the sametime to unlock them or just turn the bottom one?

Help would be greatly appreciated thank you.

 

Pretty basic procedure

Watch this Vid

Dont mess w/the double collars under the springs. That changes the spring pre-load

Also, dont just tighten the lower locking collar w/the spanner wrench. Use a hammer & flat bladed screw driver & drive the collar tight

 

mine is the basic coilover so it only has the two perchs under the springs no third perch, do i just undo the bottom one than? I dont think i can a
djust my preload either

 

Not familiar w/that setup. I would just call Tein customer service & have them explain it or take a picture of the strut & post up & we can figure it out

Im curious what this C/o looks like

EDIT: likely this

 

Will do, i have work and school so i'd prob wont be able to post a pic til saturday but stay tune and thank you MinusPrevious

 

Yah i pulled my wheel off the other day and tried and it looked like that but the threads were alittle longer.