Hi Forum Members,

So, I just picked up a set of Nitron R3 and it came with all (maybe) the hardware to install. I think i have an idea of where the fronts reservoir goes but not sure about the back. Has anyone here installed R3? Or have any instruction? I tried to contact Nitron UK and they are pretty much useless. Nitron US didn't even answer .....

Thanks!

 

I doubt they have instructions available. Here's an example of remote reservoir mount if that helps:
https://www.evolutionm.net/forums/ev...rs-review.html

 

Yep, I saw this. But the rear, it looks like the MCS reservoir can be detached to run the tube to the trunk (that is a nice setup thou); the Nitron cannot be detached. Unless there is a way to fit route that reservoir to the trunk without detaching it, let me know =)

 

Ah, that's a bummer. I'd look for a good mounting point on the unibody frame rail or rear subframe that's not going to interfere with any of the suspension links and that is out of the way of getting hit by road debris. The Nitron's pricey so you're going to have some trouble finding anyone with the same setup.

 

Hi mate how did you end up installing it? Please update. Thank you.