Bought my Evo in 2011 and I blew the motor last year. The rims were damaged so i decided to get them Baked Orange. Fast Forward Wheels in South El monte California Did them and they came out beautiful. More about the care

Mods:
ETS Intake
ETS UICP
ETS LICP
ETS FMIC 4.5 Inch
ETS 02DUMP
UR Cat Back
RC 1200 CC injectors

PUMP 91: 337/ 343
CORN E85 400/ 368

RIM : Ce28n 19X10.5+12
TIres: forgot Tires but size is 265/30/19


While The Care is down i managed to pick up
CBRD BBK FUll
Kelford B cams and Retainers

Hopping to make over 400whp on pump 91 Squirrel ****

Car Still needs the motor and currently is being installed. I will update the car photos as it will sit lower and i will update this thread with new power numbers as well.

Sorry for photos, they are from and old Phone.

 

Looks nice. If u don't mind me asking, how did the motor blow? Is that typical for 5 years?

 

I actually dont know. It seems like the timing belt was streched and it snapped and thats when things blew. I dont think this this typical either, maybe just bad luck.

 

Wow, yeah a stretched timing chain seems like terrible luck. Either way, I hope everything works out (and for not too much money, lol)

 

Is it me or do 19s look a lot better than 18s on the x,what are some of the cons of going with 19 inche wheels

 

*timing chain


And I know your pain. Im still running in break in miles on my motor after the top ring on cylinder 3 went. I'm running the bbx full as well, and I can imagine both of us being 400+ on pump gas. Excited to see what you're able to put down with it man.

 

tires are bit more expensive. I had the Nt03 before in size 18 and the vehicle handles to same IMHO. The car does not rub but i do have the fenders rolled, i guess it just depends on the setup. I have a +12 offset and I like the the way the car stands. Once the motor is in i will detail the car and post up some photos

 

Im hoping for 400+. I know i will be there on E85 but i would like to be there on Pump. Im thinking of building the blown block on the side in case anything ever happens again- then i could start on a serious build.

 

Just got the car on the dyno, happy with the results. please go to link for details.

https://www.evolutionm.net/forums/ev...91oct-e85.html

 

I did the timing chain after it skipped a tooth or two. Cost me a little over 1k at the dealer =(