Profec B Spec II
Profec B Spec II
So, I'm going out tonight to fine tune by EBC and I have a few questions. I searched. I was reading how to tune here...
https://www.evolutionm.net/forums/sh...ht=tune+profec
-The Gain on my unit will not go to 0% The lowest it will go is 5%
-Also it says to set the Limit 4% lower than the Set %. My limiter wont go any higher than 20%.
Do his instructions mean to just set the limiter at 4%?
Also I want to be boosting about 21-22psi. I'm spiking at 19 and then tapering off to in between 17 and 18 psi. I know I have to fine tune the gain and all.
Right now I have Set at 57% with gain at 17%. Set Gain at 15. Warning 200 and Limter 10%. Normal? I dont know how high is to high to raise gain and I guess I'm just nervous when playing around with boosting my engine. Thanks in advance.
Nick
https://www.evolutionm.net/forums/sh...ht=tune+profec
-The Gain on my unit will not go to 0% The lowest it will go is 5%
-Also it says to set the Limit 4% lower than the Set %. My limiter wont go any higher than 20%.
Do his instructions mean to just set the limiter at 4%?
Also I want to be boosting about 21-22psi. I'm spiking at 19 and then tapering off to in between 17 and 18 psi. I know I have to fine tune the gain and all.
Right now I have Set at 57% with gain at 17%. Set Gain at 15. Warning 200 and Limter 10%. Normal? I dont know how high is to high to raise gain and I guess I'm just nervous when playing around with boosting my engine. Thanks in advance.
Nick
Last edited by xxNosTankxx; Aug 9, 2007 at 03:28 PM.
OK your not going to boost 21-22 with the warning on 200. ARe you happy with your taper as it is now? If you are just raise your warning to 23-23.5 and turn your % up about 1-2% at a time till you get there
