Car won't start after fuel pump install
#1
Newbie
Thread Starter
Join Date: Mar 2009
Location: Napoleon, OH
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
Car won't start after fuel pump install
So, I'm in a prediciment. I swapped out my stock pump with a new Aeromotive 340lph. I swapped the wires around to make sure the polarity is correct and everything went together without a hitch. I go to start it, and it just turns over. I'm getting fuel to the rail but it still won't start. I blead the fuel feed line as well, but it seems like it isn't pressurizing the system. Any advice?
#2
Newbie
Thread Starter
Join Date: Mar 2009
Location: Napoleon, OH
Posts: 0
Likes: 0
Received 0 Likes
on
0 Posts
I figured it out! I was getting 7 volts to the pump but low voltage wasn't my only problem. I swapped sending units because something must have been messed up between where the connector plugs in and where the fuel pump plugs is too. After the swap, it runs like a dream finally.
#4
Evolved Member
iTrader: (29)
I figured it out! I was getting 7 volts to the pump but low voltage wasn't my only problem. I swapped sending units because something must have been messed up between where the connector plugs in and where the fuel pump plugs is too. After the swap, it runs like a dream finally.
Thread
Thread Starter
Forum
Replies
Last Post
fugiwara
Evo Engine / Turbo / Drivetrain
32
Aug 29, 2013 09:59 PM
EVO8_PR
Evo Engine / Turbo / Drivetrain
0
Sep 7, 2008 01:56 PM