Evoscan 2.4 and ACRelaySw field
#1
Newbie
Thread Starter
Join Date: Nov 2006
Location: Orange, Ca
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Evoscan 2.4 and ACRelaySw field
I've been using Evoscan for a bit and finally wanted to check on my AC relay switch (I'm guessing this is the field that the results show in).
So checking my logged data and the ACRelaySw (request 49, function x bit 4) field, my log is showing a 0 and 1 in the log (my guess is 0 is off and 1 is ON). Sooo my problem. The display is showing 0 AND 1 intermittantly. I did not turn my ac on and off so I don't understand the 0 AND 1 occurring?
Or should I only be looking at the Air Conditioning Switch? I just realized that I did not tick that box to log. However, I still do not understand why the RELAY would be displaying both on and off...and most importantly I feel like for the last couple months my car has been getting very bad gas mileage and I usually drive W/out the ac on. Sooo I'm curious if this could be an issue for me.
Any ideas/thoughts?
Thanks!
So checking my logged data and the ACRelaySw (request 49, function x bit 4) field, my log is showing a 0 and 1 in the log (my guess is 0 is off and 1 is ON). Sooo my problem. The display is showing 0 AND 1 intermittantly. I did not turn my ac on and off so I don't understand the 0 AND 1 occurring?
Or should I only be looking at the Air Conditioning Switch? I just realized that I did not tick that box to log. However, I still do not understand why the RELAY would be displaying both on and off...and most importantly I feel like for the last couple months my car has been getting very bad gas mileage and I usually drive W/out the ac on. Sooo I'm curious if this could be an issue for me.
Any ideas/thoughts?
Thanks!