anyone have the diagram/ wiring setup to log with the pwr fc. i thought i saw it on here awhile back, but cant seem to find it.

 

setting up datalogit to read the AEM 0-5V signal or just to get the O2 reading to register in the PFC.

If you just want the PFC to read the output of the AEM then set the analog output to 0-1V and send that signal back into the ECU O2 sensor signal wire (Pin 76 ) and it would read in the PFC.

Getting the PFC to adjust fuel mixture is another story.

 

yup, thanks i figured it out. right after i posted. haha