What do i do with the blue, green and black wires coming off the relay? I am trying to pair this with my map switching setup (pictured below). ECU expert please chime in! Thanks.

 

Working backwards from the ECU pinout, from ECU pin #64 to relay 87A and back to JOT harness out 30 on the relay back to the harness wire you intercepted and cut.

Relay #85 to ECU 12V red/gold stripe wire at the ECU.

#86 to white wire output from the Zeitronix ZAVT. White wire will disable ALTMAP when ZAVT alarm is activated.

Be sure to set alarm length in seconds within the Zeitronix software.

 

Thanks a lot TTP. Just want to be sure..Am i cutting ecu wire #64 and attaching relay wire 87a to the ecu side and relay wire 30 to the JOT side of that same wire?