Hi
I have the zt-2 and wanted to know how to get the map sensor cable from the engine compartment to the cabin, so that i can connect it to the control module??
any pic or link would be greatly apreceiated.....I dont need how to wire it, just how to get it past the bulkhead?
thanks

 

anyone???

 

ttt

 

I just drilled a hole in my firewall and poked it through. Use a rubber grommet and it will be sweet.

 

thanks for the reply , i found a hole behind the passanger strut tower the allow for access into the cabin. im in!!!
now Ive wired it all and just need to install the o2 sensor....this is the 09 or earlier model....but currently the lcd dosent light up? is that because it's still not connected to the o2?