x cams and deck milling
Aug 23, 2009, 04:01 PM
#1
Newbie
Thread Starter
Join Date: Jun 2009
Location: ky
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
x cams and deck milling
im thinking about doing this but i will have to send my block to golden eagle or or some place with a good reputation
im looking in to doing a all motor set up but were allready bored and stroked so im looking for other options with out boost i know evo cams are good for there boost curves but should be more aggressive than are stock cams in the 2.4 along with evox springs and titaniam retaners port and polish head and intakemanifold i think i can pull some good numbers with other basic bolt ons cold air intake, full exhaust, piggy back ecu, mivec controller , air fuel controller , lookin at also mishimoto evo x radiator and tranny cooler
let me know what you guys think i think we could see some good numbers out of n/a 09 lancer gts i think its possible to brake 200 whp
enough cash can make any thing possible
off topic went to the track and all motor civics were woopin boosted mustang 5.0 and 08 rallyarts
im looking in to doing a all motor set up but were allready bored and stroked so im looking for other options with out boost i know evo cams are good for there boost curves but should be more aggressive than are stock cams in the 2.4 along with evox springs and titaniam retaners port and polish head and intakemanifold i think i can pull some good numbers with other basic bolt ons cold air intake, full exhaust, piggy back ecu, mivec controller , air fuel controller , lookin at also mishimoto evo x radiator and tranny cooler
let me know what you guys think i think we could see some good numbers out of n/a 09 lancer gts i think its possible to brake 200 whp
enough cash can make any thing possible
off topic went to the track and all motor civics were woopin boosted mustang 5.0 and 08 rallyarts
