ROAD/RACE-We have underdrive pulleys
Originally Posted by CarnEvil101182
will the grounding kit help that dimming?
I have a ground kit and have a 1000W+ system. I get the dim as well. However, its not THAT bad. With ALL the accesories running (fogs, rear defrost and all night time driving lights) the out put goes from 14.5V down to about 12.5 at idle. As soon as you breath on the gas pedal though it shoots back up to 14.5.
No biggie. Still a great mod in my opinion.
I was going to pm this question rock but i figured other may want to know.
How much is it for an extra belt/replacement belt from yall? And what belt would we need to get if we have to buy a replacement at an autoparts store?
BTW - i will be ordering my pulleys online tonight.
How much is it for an extra belt/replacement belt from yall? And what belt would we need to get if we have to buy a replacement at an autoparts store?
BTW - i will be ordering my pulleys online tonight.
Here is something I found on AEM's website, not sure if its been asked or addressed so I thought I'd bring it up. Is this true for our car aswell?
Question
Why doesn’t AEM make a crank pulley?
Answer
Virtually all of the cars we make Tru-Power pulleys for come equipped with a vibration dampener mounted to the crank from the factory. Aftermarket crank pulleys require the removal of these dampeners, which are required for engine life. Their removal can cause damage to your engine over time. If the manufacturers could save on vehicle costs by eliminating this device they would have done so.
Question
Why doesn’t AEM make a crank pulley?
Answer
Virtually all of the cars we make Tru-Power pulleys for come equipped with a vibration dampener mounted to the crank from the factory. Aftermarket crank pulleys require the removal of these dampeners, which are required for engine life. Their removal can cause damage to your engine over time. If the manufacturers could save on vehicle costs by eliminating this device they would have done so.
Thread Starter
Former Sponsor
iTrader: (67)
Joined: Dec 2001
Posts: 7,826
Likes: 3
From: Santa Fe Springs, CA.
When you get the belt, the belt # will be on the package. You can buy belt from any autoparts store. As for 02-03s, we are working on a a lightweight one for you. It may not be underdriven but for sure will cut 3/4s of the weight off of it!
ROAD/RACE
ROAD/RACE
rock, do you have any comments about what psychlancer said above. Do you know if this is true, or maybe we have a different type of pulley system than they are talking a bout. I am really interested but i would like to know they are safe for my engine.
As far as that's concerned you might want to check out joe's post from when he started making these, it's gives you all types of info...
I've had mine on for about 5K miles... (a couple 300 mile trips) and it's working perfectly!!!
https://www.evolutionm.net/forums/sh...d.php?t=149402
Lots of info in there!
I've had mine on for about 5K miles... (a couple 300 mile trips) and it's working perfectly!!!
https://www.evolutionm.net/forums/sh...d.php?t=149402
Lots of info in there!
Thread Starter
Former Sponsor
iTrader: (67)
Joined: Dec 2001
Posts: 7,826
Likes: 3
From: Santa Fe Springs, CA.
That can be true but in most instances, the pulley on a stock motors cost manufacterers a $2 dollars. THey are not balanced unto themselves because they are cast pieces. Our pulley are CNCed and completely balanced units.
ROAD/RACE
ROAD/RACE
