looking good man

 

thanks for the quick reply and info. this will probably be one of my next couple mods. keep up the good work on yoour project and i cant wait to see how it turns out.

David

 

whens it go to paint ?

 

well i have to finish molding everything on and i have a lot of interior fiberglass work to do as well. i am probably going to wait until i have the whole car, inside and out, ready for paint before i even worry about painting any of it and just do it all at once. i have decided i am going to mold the whole kit onto the car instead of just the rear and sides like i wanted to do. i have two other vehicles, a 64 mercury monterey and a 2003 hond 954rr, that i can drive instead of this one, and i may acquire more before this one is done so i am just going to make it a show car that i drive every once in a while. so i am not too worried about wrecking it or anything. that was the main reason i didtn want to mold the front on, because it would eb the hardest to repair. but i think im gonna do it anyway. i am also doing fiberglass door panels and some other interior work as well, i.e. fiberglass stereo in rear section and custom fiberglass spare tire well in trunk, so paint is a long way off. but i will keep everyone posted on the progress. i hope to start molding and stuff after christmas, gotta save money till then.

slimm

 

so is tht like bondo, a sticker or wht on da door? and how hard was the fitment for the fenders(they look great by the way)

merc

 

well its where i guy hit my car and i fixed the dent and sprayed over it with primer. the fenders have slight imperfections in them, fitment is good, its just that on one side the cutout area for the headlight is not erfect. and one problem with shipping, but other than that they are beautiful. i would recommend accolade to anyone.

slimm

 

so u didnt have any problems wit the fender install?

merc

 

none at all, i ahvent gotten them completely bolted on yet, but i put them where they need to go and they fit fine. the places that it has to drill holes are off a little, but if you drill where they need to be the fenders will fit fine.


slimm