ok i decided to make a new lip again,and if u remember i made one last time out of an integra lip .this time i went to the junkyard and pick up a lip from an older toyota cressida or somethin, well this one was bigger and had more flare to it, anyways heres the pics
the lip came in 2 pieces off the car

and here is the extra peice i had to add to the center b/c like last time it was to short

and here are some almost finished pics

now u can see where i had to add the center section

and now the finished pics

here u can notice the flare this lip has on the ends, i like this one better than my last one, it also is about an 1/2 inch taller too

 

Hotness!!

 

that looks really good dude. Nice job

 

looks slick. very nice work.

 

Very nice DIY!!!!

 

I like that lip more than the other one. Awesome job.

 

start selling those for like 300 a pop. I bet it would look even better painted. Great work! That's what I call innovative and tasteful

 

thanks peps, selling them wouldnt be that bad of an idea

 

Looks amazing What did ya do with your old lip?

Also, what's wrong with your hood vent?

 

Would you consider selling the old lip that you made? The new one looks great.

 

that lip does look really nice, i could see one of those in black on my car...

 

my old lip is kinda in 2 peices

 

Lip off a Old Toyota Cressida? ingenious...

I can't believe there's not other car out there that remotely shares the same length of our bumper/lip...

 

woot! that looks great. the other looked great as well but that one tops it by far. awsome mod.

 

that looks awesome. round what year toyota is that off of