Barely had to do any chopping to the Walker to make it look similar to the Ralliart. Also, Ralliart is like a stock height bumper, do you guys want that (different style but stock lenght) or a lower kit to make it lower to the ground.

Also, with the Ralliart bumper, does everyone actually like the look or the name? I think it looks close to stock, I think the craze is it comes with the Ralliart name.

Also, anything special for the sides of the front bumper or just flat?

 

i can do a wide body kit with that bumper. i am actually working on a custom widebody for my personal car but that wont be publically available. but if we end up doing a wide body it will probably cost a little more.

 

Ya, that's expected. It would include fenders.

 

here is a shot of the rear bumper

 

Hehe, from NFS: Undergound?

 

I would lower the front lip and pull out the bottom so it doesn't look like it comes into the car

 

so far super_rob has been the only person to give us an idea for the rear and i like it. what does everyone else think. remember this is a new body kit that we are allowing you guys to have a say in the design of. that doesnt happen very often.

 

Here are a couple more shots

 

OK, did some touchups... lowered lip a little.

 

here are som shots of the DAMD bumber/kit I was going off of:















I was thinking that just the bumper would be a good idea and keep it simple with the OZ-style skits and rear...but something like in the first pic would be good, especially for the ES & LS models. I also really like the vents on the side of the DAMD.

 

I like the idea of the cutouts, not sure about the center back lower piece (the design). Cool pics though, I will need to load up NFS and check out some ideas.

 

Ya, the pics of the Damd kit is similar to the walker kit except the two cutouts above the intercooler hole.

 

Yes NFS, has alot of body kits on there that look great on the car and the best thing is you can see what it will look like, but there are great kits out there just wait to be made here is my lancer right now. I have the JT AUTOSTYLE kit i love the front bumper but everyone has the same sides and rear, I need something more, if you make that rear bumper slim I want the first one made.

 

well actually I extended the bumper above the intercooler hole cause it's uber think on the 'Walker' kit and it looks really square. I also cut out the bottom to make it more like the actual DAMD, which is sorta Blitz styled. Basically the bumper I designed shares the front and side vents, as well as the height/width with the 'Walker kit.

also, are you thinking of a hood conversion too (like the Accolade Evo VII)? cause an Evo VIII hood would be hella sweet! Even if you don't have the grill extention, something like this would be cool: