Thanks Del. As for a pillar, it is drilled for 52mm but can be opened up for 60mm. Glove box plate is designed to mount a variety of gauges and controllers. It is an attractive way to properly mount these items so that they are tipped up to see them and of course with it in glove box thieves will not be tempted to bust a window and steal this stuff.

ROAD/RACE
http://www.roadracemotorsports.com/

 

Is it the same pillar for Evo and Lancer?

The reason I ask is because if I pay $260 for these I don't want trapazoidal holes of grey poking out through the CF.

Definitely interested, but dassaloddamoneez.

 

thank you hobie for asking my question.

also, will it be possible to order just the driver-side pillar? i think just having the one replaced would be very feng shui.

i am extremely interested in getting this, but really only want the driver side pillar. thanks ROCK.

 

Right now it is a set. Always hard to please everyone. This was desigen mostly for EVO guys but U.S. Lancer guys can benefit from it to. Each mold is expensive so variations will have to have some real demand for it first.

ROAD/RACE

http://www.roadracemotorsports.com/

 

thanks ROCK. i have to wait a bit anyhow. 3 scratches and a broken tail-light are first on my list. bad luck.

put me hobie and me down for the first two with demand for no tweeter cut-out, and me with single pillar availability.

 

Word.

EDIT: I like the mold as is (2 pod) minus the cutouts I have to say. I take it the coutout is part of the mold then and you're not just cutting out that section once it's done.

 

i just sent you $69 via paypal for the glove box pod

 

Hey, hows the tuna here.

 

Post pics once you get some gadgets mounted in the glove box plate.

ROAD/RACE
http://www.roadracemotorsports.com/

 

Got 4 sets of a-pillars in today. Guys who called we have them now.

ROAD/RACE

http://www.roadracemotorsports.com/

 

So are these full replacements, where you pull the existing off, just covers that fit on top, or both (either)?

 

While you're at it Rob, does the mold have the cutout for the speakers or do you guys cut them out after the CF has been put in the mold?

 

Mold has the cutout. These fit over existing a pillars.

ROAD/RACE
http://www.roadracemotorsports.com/

 

i would like a set of the cf pillars without the tweeter cut-out.. think that makes 3 of us so far.

 

i want fiberglass!!! hehe...rock are you guys gunna start making fiberglass pillars?