"Incognito" Hidden Dry system

Comes with 1.4lb bottle, solenoid, fill fitting, -4 cap, 10ft poly line & assortment of jets.

$235 Shipped

 

pic

 

NX EFI Nitrous system

complete with 5 lb bottle, pure-flo btl vlv, 60 amp H.D. relay, WOT switch, all HP settings, shark nozzle, stainless steel bottle bracket, 16 ft. stainless steel braided -4 supply line, nitrous filter and installation

$589 shipped

with 10lb bottle

$599 shipped

 

this isnt much of a nitrous crowd here. nitrous does not get along with our motors very well.

 

how about one of those systems where it goes infront of your intercooler?? got any of those?

 

you have a PM

 

haha i bet everyoens gonna be pissed when their motors are blown

 

i think the reason there motors blew is it would send most of the nos into the first cylinder..hence the cylinder rings blowing....

im sure if u had direct port nitrous and forged pistons you'd be better off....but i could be wrong still...

 

How would our stock engines hold up to a small shot, say 50-75?

 

a 50 shot should be fine

 

Is there a 35 shot by chance? What about spraying it directly on the short ram intake, could that do anything, or would it dry it out too much?

 

Spraying into the short ram is fine, its just a dry setup

 

id rather use a 50-75 shot 'direct port' nitrous....it's much safer than a dry/wet shot, because it is evenly dispersed over ALL the cylinders and pistons...not mainly into the first cylinder/piston...

if u saw the 'nitrous' pics only 1 or 2 of the pistons were torn up....the others were fine....

so invest in a direct port kit...or custom it urself...and get some forged pistons and u go on with ur bad self on that 100 shot

 

Hmmmm - so if i got one to spray on the filter of my CAI, would that have any effect? Or on the radiator?

 

if you put a nozzle in the intake you would have an effect, like getting serious cold air.