okay so I installed my aftermarket steering wheel setup
(personal wheel, works hub, nrg quick release)
Plugged in 3.0ohm resistors to eliminate the airbag warning
that same day I drove back and fourth to the tire shop to get tires installed about 22 miles total? No light
I took it out today and the asc service and airbag light came on while driving
its annoying cause it keeps beeping. NOW I checked the asc fluid and its full

only other thing I can think of is either the steering sensor is off or I broke the clockspring or something.

and my steering wheel has always been off after I lowered my car and changed the tires. I have not got an alignment cause I really never drive the car until now.

any opinions would be great

 

have the codes read

 

I got those CEL's when I disconnected the steering shaft and broke the clock spring. A new clock spring from Mitsu is ~$90 and it's a $100 to have them reset the steering angle sensor.

 

Maybe a bad steering angle sensor. Just hope its not the clock spring.