Here are two custom sets of Wiseco 1400hd pistons in 11.5.1 compression, although this can vary depending on headgasket,head milling, and block milling. They include upgraded wrist pins and a full set of rings. They are 3.660 2.0l (+.020)Bore size and brand new in the box never hung on rods. They have been hand detailed (deburred and smoothed) and are ready to go. This is not an off the shelf piston. I have two sets of these exactly the same, one set was for my Evo 8 wich I just traded for an X and the other for a DSM project car that was recently discontenued. These are 7 bolt pistons with 22mm HD pins. Each set comes with the custom build sheet info. These were intended for use with aluminum rods so growth was accounted for by recessing them .013 in the bore IIRC on the measurement. They have large enough valve relief pockets to accomodate 13.5mm of lift, again that depends on valve diameter,gasket thickness, and any milling.

Thanks for your interest.
$650 per set two sets available.

 

^damn! GLWS!

 

Thats wicked high compression lol

They look great tho man, glws

 

Thanks. They were intended for E85/Methanol use. If they would fit a 4b11 I would be keeping them.

Bryan