Mark this thread as Unsold
FS: RRM 10.5:1 Lancer pistons
Thread Starter
EvoM Staff Alumni
iTrader: (88)
Joined: Aug 2003
Posts: 8,733
Likes: 3
From: Concord Township, Ohio
No, I can't make up my mind. 
Mostly it's that no one will buy them, so for a few weeks I'll be like "I should just use them!" Then I look at my bank account.
Mostly it's that no one will buy them, so for a few weeks I'll be like "I should just use them!" Then I look at my bank account.
Last edited by Blacksheepdj; Jun 7, 2005 at 07:45 AM.
What's an estimate of installation cost for these? I'm browsing different ideas for my next power/suspension mod. I just ordered a bored IM and am now considering bored TB, full coilovers, and now these. Do you need/ is it recommended to have some sort of piggyback like the emanage for these?
Thread Starter
EvoM Staff Alumni
iTrader: (88)
Joined: Aug 2003
Posts: 8,733
Likes: 3
From: Concord Township, Ohio
Depends on who you ask. The two estimates I got were $400 and $500ish. So not too bad. Hell, you could probably do them yourself fairly easily. That was my plan.
Stock fuel system will run just fine with these. Probably wise to bump up to Premium gas just to be careful and avoid detonation.
Stock fuel system will run just fine with these. Probably wise to bump up to Premium gas just to be careful and avoid detonation.
