WILL SELL SEPARTLY IF NEEDED

Dejon Tool Upper intercooler pipe w/ 3" GM MAF sensor flanged for Tial BOV- USED FOR 20 MILES only. DEJON sells the pipe for 165$ and the MAF sensor is 159$ will sell the assembled pipe for 280$

This allows you to vent the BOV to atmosphere without affecting the Air/Fuel ratio for good drive-ability. See fuel & electronics page for GMAF30 and Trans-EVO.

MAF TRANSLATOR- The MAF Translator will allow the use of a GM MAF sensor on the Evo 8 and 9 turbo cars. This low restriction unit will drastically improve spool up time and air flow. The Translator will also allow for full fuel control so that you may tune your car for changing conditions or modifications. You may also compensate for different injector sizes when you reach the time for an upgrade. Simple plug in installation plus 1 wire tap is all you will have to do.

new is 195$, was in the car for 20 miles only. will sell for 175$

Dejon Tool 3" intake pipe w/ Air Filter. used for running a blow through setup, gets rid of stock MAF sensor . new is 105$ will sell for 95$

NEW would be 624$ and this setup is still brand new. sat in car for a week and was driven to a dyno but we had a problem and now the motor has to come out. will sell entire setup for 575$ for the upper intercooler pipe w/ MAF , intake pipe and the MAF translator SHIPPED!!!!

MY ACTUAL SETUP


INTAKE

 

everytime i think of that tiny little restrictive MAF i think WTF were mitsu thinking when they used that, how much for the gm maf and translator only?

also what do you do for IAT sensor with this setup? Thanx

 

dargnez you have a pm, bump

 

also what do you do for IAT sensor with this setup? Thanx[/QUOTE]

+1

 

Sold!!!

 

Hey, I still have not received the intake pipe! You have many of my PMs and I've gotten all of the receipts back, so that means that you've read them. Please stop avoiding me and get me my intake pipe, or refund me $95.

 

Still Don't Have The Intake Pipe From This Guy! Warning To All! Do Not Buy From This A$$hole!!