Mark this thread as Unsold
Evo VIII block, 4G64 100mm crank
Evo VIII block, 4G64 100mm crank
Up for sale is an Evo VIII 4G63 block, a 4G64 100mm crank and Cosworth rods. Block is bored 20 over but is still good. All it needs is the cylinders to be re honed so your new rings break in good.
The 4G64 crank is beautiful as well. Came out of this same block. Was a built 2.3L stroker motor. Crank was milled down to use .025 ACL Race bearings. It was re nitrided and magna fluxed. Only reason the motor came apart is because I wanted the rods and pistons.
I also have a used set of Cosworth rods with ARP L19 bolts if anyone needs them for a 2.0L or 2.3L build. One of the rods has a little bit of damage by the piston rist pin whole. You can run it the way it is or have it fixed by a machine shop
4G63 block SOLD
4G64 crank SOLD
Cosworth rods $200
Located in Victorville, Ca 92394
PayPal and shipping available
The 4G64 crank is beautiful as well. Came out of this same block. Was a built 2.3L stroker motor. Crank was milled down to use .025 ACL Race bearings. It was re nitrided and magna fluxed. Only reason the motor came apart is because I wanted the rods and pistons.
I also have a used set of Cosworth rods with ARP L19 bolts if anyone needs them for a 2.0L or 2.3L build. One of the rods has a little bit of damage by the piston rist pin whole. You can run it the way it is or have it fixed by a machine shop
4G63 block SOLD
4G64 crank SOLD
Cosworth rods $200
Located in Victorville, Ca 92394
PayPal and shipping available
Last edited by EvokidIX; Jan 20, 2014 at 11:09 AM.
